Common problems with linear guide sliders: adding oil, grease lubrication, and grease lubrication to the linear guide: it is recommended to lubricate it for the first time or for supplementary lubrication.

1. Wipe off the rust proof oil on the surface of the guide rail and slider to avoid the rust proof oil diluting the lubricating grease.

2. Fill the entire internal space of the slider with lubricating grease until it just overflows.

Due to the excellent scraping and sealing effects of some slider wiper blades, applying lubricating grease on the surface of the guide rail cannot enter the interior of the slider and cannot provide lubrication.

The interval for supplementing grease lubrication: for sliding blocks of size 30 and below: replenish every 100km. 35 and above sliders: replenish every 40km. The time interval is to replenish every three months, but the replenishment interval shall still be based on the earlier of the above two.

Oil lubrication:

1. First oil injection on: Fill the internal space of the slider.

2. Supplementary oil injection amount: Q=n/150 (cm3/hrs)

n: Linear guide rail nominal model width (mm)

3. It is recommended to follow the manufacturer's instructions for the oil specifications

Common problems with linear guide sliders

1. After using it for a period of time, it was found that there were indentations on the track of the guide rail and the steel ball of the slider was broken. What is the reason for this?

The main reason is overload, which causes the steel ball to detach from the track, causing the steel ball to break and causing damage to the track. You can replace the slider with a larger one, increase the number of sliders, reduce external loads, and change the installation method to reduce unilateral stress. If the reason lies in lubrication, you can try using another type of lubricating oil, increasing the amount of lubricating oil and reducing the lubrication spacing. It is necessary to regularly check for foreign object intrusion, and if there is foreign object intrusion, it is necessary to improve the sealing accessories.

2. What is the situation where steel balls will fall off and peel off after using the slider for a period of time?

The peeling of iron filings from the bead groove leads to the end of the steel bead damage life, causing fatigue and excessive adhesion on the surface of the iron piece. Possible reasons include excessive adhesion, incorrect installation, or unilateral force.

3. After walking the slider for a period of time, did you find any deformation or fracture between the end cover and the end dust?

The incorrect installation method may result in only one side of the force between the slider and the track, or it may be affected by external forces that cause deformation or fracture of the end cover and end dust. If the internal part of the slider is defective, the dust prevention system can be changed, the lubricating oil can be improved, the amount of lubricating oil can be increased, and the lubrication time interval can be reduced. During installation, attention should be paid to the issue of installation angle, and the optimization of product configuration requires professional technicians to install to avoid damaging the guide rail slider.